We are deck builders in Yarmouth, ME for homeowners planning a new pressure-treated deck, a composite or PVC deck, or a complete replacement of a worn one. We start with your lot, your entry height and the way you want to use the space.
Southern Maine Deck Builders plans and builds new pressure-treated decks, composite or PVC decks and complete deck replacements in Yarmouth and across Cumberland and York counties.
Planning figures are about $80 per square foot for basic pressure-treated work with a $10,000 minimum, about $100 to $120 per square foot for complex or upgraded work, and a $15,000 minimum for composite with project-specific quotes. These figures are not binding quotes.
Each project starts with a site visit covering the parcel, access route, ledger connection and footings, followed by a written scope you review before any work is scheduled.
Choose deck builders in Yarmouth, ME who explain the whole job in writing before any lumber is cut. We list the structure, material line, demolition, stairs and rails for each project, so you can compare our scope line by line against any other quote, because two prices only mean something when they describe the same deck.
The right deck material for a Yarmouth home depends on how much upkeep you want, how the deck sits in the sun and what you plan to spend. Here is how our three project types compare.
Pressure-treated wood is a direct way to get a sturdy, practical deck. It has a natural feel underfoot, it is simple to replace one board at a time, and it fits the lowest planning figure we offer.
The tradeoff is upkeep. Wood moves as it dries and weathers, so plan on periodic cleaning and a fresh stain or sealer on a schedule that suits how much sun and moisture the deck actually gets.
Composite and PVC boards skip the stain and sealer cycle, which suits owners who would rather wash a deck than refinish it. The look is more uniform board to board, and the project minimum starts higher than wood.
Boards can run warm in full sun, and installation details differ by product. Gaps and fixings need to match the selected line, with cleaning guided by its care instructions.
We work from the chosen maker's current instructions, such as the Trex installation downloads when Trex is selected.
Complete replacement means removing the existing deck, including its framing and supports, and building a new structure in its place. It makes sense when the frame, ledger or footings are uncertain and new boards would only cover the problem.
We cannot judge an unseen deck from a photo, and we do not tell anyone a worn deck is safe to use. The site visit records what we see, and the written scope lists demolition, disposal and every new structural part.
We offer three deck services in Yarmouth: new pressure-treated decks, new composite or PVC decks and complete deck replacement. Each one is planned as a full structure, from footings and ledger to stairs and rails.
The connection starts where the deck meets the house. We check the rim board and siding at the ledger line and plan flashing so water sheds away from the framing rather than collecting behind it.
Hidden fastener systems are matched to the specific board line, and structural hangers, screws and bolts are chosen to suit treated lumber, so the metal and the wood work together over time.
The step from the doorway to the deck surface is set during layout. We measure the threshold, allow for board thickness and seasonal movement, and keep the door swing clear of the finished surface.
We visit the property to measure the deck area, check the house wall at the ledger line, note door heights and walk the delivery route from the street. You then receive a written scope that lists the structure, materials, demolition if any, stairs and rails, along with pricing tied to those details.
Once you approve the scope and any required municipal steps are complete, we remove any old deck, set footings, attach and flash the ledger, and build the frame with joists and beams as drawn. Decking goes down only after the structure is checked against that plan, because the frame is the part you will never see again.
With decking, stairs and rails installed, we walk the finished deck with you and go through the written scope item by item. We point out care steps for your chosen material, clear the work area and leave you with the product information that applies to your boards and hardware.
Your lot plan should show where each footing goes and why. Support size and spacing come from the deck's loads, the framing spans and the conditions we find on your parcel.
Water needs a way out from under the deck. We note where roof runoff and yard slope send water, and keep enough open space below the framing for air to move and boards to dry.
Lumber, concrete and debris all need a route in and out. We walk the actual path from the street or driveway, noting gates, fences, septic areas, plantings and slopes before planning deliveries.
Before building in Yarmouth, we check your parcel's layout and grade, the route materials will take and the house wall where a ledger would attach. The American Wood Council deck resources give general framing background, though your design is drawn from your own site.
The Town of Yarmouth is the source for local rules, and its official permit and code information links to Building Permits and Code Enforcement and to Planning and Development. We check those resources for your parcel and bring questions to the town, since only the town decides them.
Everything we find goes into the written scope, including what we checked, what is still unknown and what would change the price. You review it before any work is scheduled, so the deck on paper matches the deck you expect.
Your Yarmouth deck is built by our Southern Maine Deck Builders crew, led by owner Adam Bennett. Adam checks the ledger attachment and supporting frame with a carpenter's care for fit, including footing placement.
In his own time he restores a cedar-strip canoe, another project that rewards patience with joinery.
We build decks in Yarmouth, where our business address is on Lafayette Street, and across all 57 towns in Cumberland and York counties, including island properties. Island and remote sites need a property review for access, delivery and scheduling, and you can see every covered town on our service areas page.
Start planning a Yarmouth deck as soon as you know what you want to build, since site review, material selection and any municipal steps all take time. Your schedule depends on the scope, the property and the town's process for your parcel, so we set dates only after the site review.
A deck should be easy to move around, starting with guards. We lay out railings along the edges that need them, keeping posts clear of doors, views and the spots where you plan to sit.
Stairs should land where you actually walk, toward the driveway, garden or yard. We plan the stair route, landing and handrail so the path feels natural and the bottom step meets firm, level ground.
Seating belongs where the light suits you at the hours you use the deck. We note sun exposure through the day and bring real board samples you can compare in that light.
A deck in Yarmouth costs about $80 per square foot for basic pressure-treated work, with a $10,000 minimum, and about $100 to $120 per square foot for complex or upgraded work. Composite projects carry a $15,000 minimum with project-specific quotes, and minimums override area times rate.
| Deck project | Planning figure | Minimum |
|---|---|---|
| Pressure-treated wood | About $80/sq ft | $10,000 |
| Complex or upgraded work | About $100-120/sq ft | Scope dependent |
| Composite | Project-specific quote | $15,000 |
These are planning figures for budgeting, not binding quotes; your written scope sets the actual price.
Send us your address, a few photos and the deck you have in mind, and we will set up a site visit to measure, review access and start your written scope.
